I took the cute Cupcake digi and printed six copies on one sheet. I knew I wanted to layer it so I colored in different parts on each image with my Copics, fussy cut them all, and layered them with little bits of foam tape. I coated the flame with some glossy accents. While that was drying, I grabbed my tile piece, added a strip of patterned paper that's cut with a curve (a scrap of some other project!). Once the flame was dry, I placed it on my tile and added a little shading on the patterned paper with a grey Copic. To finish it all off, I added a few pieces of bling, some ribbon, and some twine.
I'm playing along with a couple of challenges on this one -
Thanks for stopping by!
STAMP - MWLW Cupcake Digi
PAPER - Copic Xpress It, Basic Gray RSVP
COPICS - Wrapper: V12, V15, V17; Cake: E25, E27, E29; Layers: C00, C1, C3, R81, R83, R85, V04, V06, V09, V01, V12, V15; Candle: Y15, Y38, YR68, B02, B04, B06, C00, C1, C3; Under cake shading: C3
MISC - counter top sample, Stampin' Up! Pool Party Seam Binding; Queen & Co. Twinkle Goosebumps Clear; Purple Bakers Twine, Glossy Accents, Foam tap